Techinical terms of crystal oscillator
Learn some technical terms data before you make the crystal oscillator desgin.
1. Bin: Bin selected for crystal
2. BT: Blank thickness
3. C0: Static Capacitance
4. C0/C1: Capacity ratio
5. C1: Motional Capacitance
6. CL: Load capacitance for specified frequqency
7. DATE: Measurement date stamp
8. DFL: FL@CL1-FL@CL2
9. DLD1: MaxR/RR
10.DLD2: MaxR-MinR
11.DLD3: FirstR-LastR
12.DLD4: MaxR/RR
13.DLD5: FirstR/LastR
14.DLD6: MaxR/MinR
15.DLD7: ((MaxR-MinR)/MaxR)*100 DLD2
16.DLDH: DLD Hysteresis MaxR/MinR
17.DLDH2: DLD Hysterisis MaxR-MinR DLD
18.DLDH2P: DLD Power level of Max Hysterisis MaxR-MinR DLD
19.DLDHP Show the power of worst Rmax/Rmin DLD
20.DLDF: DLD Frequency at a specific DLD step
21.DLDP: DLD Power output at a specific DLD step
22.DLDR: DLD Resistance at a specific DLD step
23.FC: Fr/divisor FR
24.FDIF: FR-RAWFR or FL-RAWFR (based on first test)
25.FDLD: MaxFR-MinFR
26.FDLDH: DLD Hysteresis MaxFR-MinFR
27.FFM: Frequency near specified frequency
28.FL: FL@CL(Load frequency)
29.FLR: FL @CL-FR
30.FR: Series resonant frequency
31.FRM: Resistance at specified resonant frequency
32.FRR: FRM/RR
33.I: Current into crystal
34.L: Motional inductance
35.LFR: Last FR
36.LRR: Last R
37.OT: Overtone
38.PWR: Power into crystal
39.Q: Quality factor
40.RAWF: Raw frequency
41.RFOUT: RF output level RF
42.RL: Resistance at FL
43.RLD: DLD MaxR-RR
44.RLD2: DLD MaxR
45.RLD3: DLD MinR
46.RR: Resistance
47.SP50: Attenuation at 50 Ohm fixture relative to main mode
48.SPDB: Attenuation at 12.5 Ohm fixture relative to main mode
49.SPFL: Load Frequency of spur
50.SPFR: Frequency of spur
51.SPRL: Max Spur resistance at Load Frequency
52.SPRR: SpurR/RR
53.SPUR: Minimum SpurR
54.SSDB: Spur Sweep peak attenuation relative to main mode
55.SSDLF: Spur Sweep raw frequency of the local max for SSDLT
56.SSDLT: Spur Sweep maximum of (local max – local min)
57.SSF: Spur Sweep peak raw frequency
58.Status: Status of crystal test
59.TC: Time constant [ L / ( RR+Network Resistance )
60.TIME: Measurement time stamp
61.TS: Trim sensitivity